Drawing Library Electrical controller
- Electrical overload protective device (Shock Relay)
- Electrical overload protective device (Shock Monitor)
Shock Monitor TSM4000 Series
Model number TSM4000～
Shock Monitor quickly detects minute load changes
- ・The terminal block is designed with a cover for safety.
- - Analog output 0 to 10V is standard equipment
- - Equipped with an automatic backlight shut-off function, contributing to energy-saving operation
- - Panel mounting type is standardized, making it easy to connect to the terminal block when mounting on a panel.
- ・Remote monitoring is possible by combining a commercially available touch panel display with Shock Monitor.
type
Basic form
Shock Monitor TSM4000H1 Series
Model number TSM4000H1～
Economy type for general industry
- - A low-cost, simple setting type with limited functions based on the basic model
- - There are two relay outputs, which can be used as an alarm output (HIGH1) and an abnormality output (HIGH2).
- ・Up to four types of HIGH1 and HIGH2 can be switched externally as a set
Used when you want to change settings for each workpiece when transporting on a conveyor, etc. - - Equipped with a torque monitoring function (20 to 120Hz) that is effective when using an inverter
type
Economy type
Shock Monitor TSM4000H2 Series
Model number TSM4000H2～
Load following type for general industry
- - A type in which the load setting value automatically changes and follows the fluctuating load.
- ・The write cycle can be changed according to the rate of change in efficiency
- ・Absolute value monitoring is possible using HIGH2, which does not change the operating level.
type
Load following type
Shock Monitor TSM4000M1 Series
Model number TSM4000M1～
Contact detection type for machine tools
- ・Offsets the no-load operation state to 0% load automatically or via external input, ensuring quick detection of minute load changes
(two outputs: OUT1 and OUT2) - ・OUT3 is a non-offset value and can monitor absolute values.
- - The detection level can be switched externally up to 8 levels, allowing for changes in grinding wheels and workpieces.
type
Contact detection type
Shock Monitor TSM4000M2 Series
Model number TSM4000M2～
Integral power type for machine tools
- - A type that determines overload and tool wear by integrating the power for one cycle of the machining process.
- - Wear detection is possible at the upper limit (OUT2), and drill breakage detection is possible at the lower limit (OUT1).
- ・OUT3 is an instantaneous value that monitors overloads such as jamming as an absolute value.
- ・Up to 8 types can be switched externally to accommodate changes in tools and workpieces
- ・The accumulation time can be easily changed.
type
Integrated power type
Shock Monitor TSM4000M3 Series
Model number TSM4000M3～
Tool breakage detection type for continuous processing machines
- ・Power sensor for processing machines that instantly detects tool breakage
Detects broken processing tools in 0.05 seconds - - Dual safety functions: counter and wear detection
Counter function manages part lifespan, and wear detection catches tool wear - - With a built-in PLC, the moment of tool breakage can be detected remotely, and IoT compatibility is also possible.
type
Processing tool breakage detection type
Shock Monitor TSM4000C1 Series
Model number TSM4000C1～
For crushers, forward/reverse sequence built-in type
- - Simply input a start signal to stop, reverse, restart, etc. in the event of an overload without the need for an external sequence program.
- ・If normal operation does not return even after the set number of reverse rotations has elapsed, a stop signal can be output to completely stop the device
- - Overload level, stop time, and reverse time can be easily changed on-site
- ・Automatic stop when no load is applied is possible to save energy
type
Built-in forward/reverse sequence type
*Please see here for a list of DXF data.
