Zip Chain Lifter (ZSL1000*S/ZSL1000*L/ZSL0050*S)
If a malfunction occurs, the causes and solutions are shown in the table below. Please shut off the power before inspecting.
Zip Chain Lifter (ZSL1000*M/ZSL0050*M)
If a malfunction occurs, the causes and solutions are shown in the table below. Please shut off the power before inspecting.
*For servo motor drive types, please also refer to the motor manufacturer's Instruction Manuals.
Zip Chain Lifter (ZSL1000*S/ZSL1000*L/ZSL0050*S)
| Cause 1 |
Disconnected wiring or poor connection |
Solution |
Wiring inspection and replacement |
| Cause 2 |
overload |
Solution |
Eliminate the cause of the overload |
| Cause 3 |
Foreign object caught |
Solution |
Removal of foreign bodies |
Return to list
| Cause 1 |
The power line wiring is different |
Solution |
Wiring replacement |
Return to list
| 3 | Extremely slow speed when ascending or descending
Abnormal vibration |
|---|
| Cause 1 |
Disconnection of brake wiring |
Solution |
Brake wiring replacement |
| Cause 2 |
Damage to mechanical parts |
Solution |
Mechanical part replacement |
remarks |
Contact us |
Return to list
| Cause 1 |
Brake lining wear |
Solution |
Brake gap adjustment |
remarks |
Please refer to the reducer's Instruction Manuals |
Return to list
| 5 | Abnormal noise when ascending or descending |
|---|
| Cause 1 |
Poor lubrication |
Solution |
Greasing |
| Cause 2 |
Damage to mechanical parts |
Solution |
Mechanical part replacement |
remarks |
Contact us |
Return to list
Zip Chain Lifter (ZSL1000*M/ZSL0050*M)
| Cause 1 |
Disconnected wiring or poor connection |
Solution |
Wiring inspection and replacement |
| Cause 2 |
overload |
Solution |
Eliminate the cause of the overload |
| Cause 3 |
Foreign object caught |
Solution |
Removal of foreign bodies |
| Cause 4 |
The servo amplifier and motor are not connected. |
Solution |
Check the connection status of power lines (U, V, W phases) etc. |
Return to list
| 7 | Extremely slow speed when ascending or descending
Abnormal vibration |
|---|
| Cause 1 |
Disconnection of brake wiring |
Solution |
Brake wiring replacement |
| Cause 2 |
Damage to mechanical parts |
Solution |
Mechanical part replacement |
remarks |
Contact us |
| Cause 3 |
Loose fixing bolts |
Solution |
Tighten the fixing bolts |
| Cause 4 |
Speed/position command input error |
Solution |
Check the input signal |
| Cause 5 |
Servo amplifier failure |
Solution |
Inspection (according to the servo amplifier Instruction Manuals) |
remarks |
Please refer to the servo amplifier Instruction Manuals. |
Return to list
| Cause 1 |
Brake lining wear |
Solution |
Brake gap adjustment |
remarks |
Please refer to the reducer's Instruction Manuals |
Return to list
| 9 | Abnormal noise when ascending or descending |
|---|
| Cause 1 |
Poor lubrication |
Solution |
Greasing |
| Cause 2 |
Damage to mechanical parts |
Solution |
Mechanical part replacement |
remarks |
Contact us |
Return to list
