technical data Large size conveyor chain Handling

Chain can be cut and joined safely and quickly
See Screw Lock Link here.

バナー画像

3. Trial run

After installing the chain, perform a test run before starting actual operation. Check the following items during the test run.

3.1 Before the test run

  • 1. The T-pin at the joint is installed correctly.
  • 2. The chain slack is correct.
  • 3. The lubricate is proper.
  • 4. The chain is not hitting the case, cover, etc.
  • 5. No bolts or nuts are left untightened.

3.2 Trial run

  • 1. There is no abnormal noise.
  • 2. The chain is not vibrating.
  • 3. The chain is not riding on the sprocket.
  • 4. The chain is not wrapped around the sprocket.
  • 5. The rails and sprockets are installed in good condition.
  • 6. The rollers rotate smoothly.
  • 7. There are no stiff points where the chain bends.
  • 8. When viewed from above, the chain is not misaligned or meandering.

⚠Caution​

  • 1. After installation, perform a test run by turning the power on intermittently several times with no load to check, and then start continuous no-load operation.
    Before test driving, oil the chain to allow each part to break in.
  • 2. Even if you cannot lubricate, please perform break-in driving.
  • 3. When attaching slats, aprons or buckets to the chain attachment, perform a test run with the bolts and nuts loosely tightened, and then tighten them completely before starting actual operation.