technical data Coupling Selection and Procedure
If you would like to see the selection procedures and important points, please proceed below.
If you would like to narrow down or tentatively select a product series,
Please click here.
If your usage conditions have been decided and you would like a detailed selection,
Please click here.
Stainless steel Roller chain coupling selection
1. Conditions of use required for selection
- (1) Daily operating hours
- (2) Load characteristics and type of prime mover
- (3) Transmission power kW, rotational speed r/min, torque N・m
- (4) Shaft diameters of both shafts
2. Selection method
- (1) Depending on the conditions of use, calculate Service factor from the Service factor table on the right.
- (2) The transmitted power (or torque) is multiplied by Service factor to obtain the corrected transmitted power.
(or correction torque). - (3) Select a coupling from kW ratings table that satisfies the corrected transmission power (or corrected torque) at the rotational speed to be used (see the table below).
- (4) If the required shaft diameter exceeds the maximum shaft diameter of the selected coupling, use a coupling one size larger.
- (5) If a standard key is used, the surface pressure may be excessive. Therefore, calculate the surface pressure of the key and consider whether a special key or spline is necessary.
| Load Nature | Type of engine | ||||
|---|---|---|---|---|---|
| electric motor turbine |
steam engine gasoline engine (4 or more cylinders) |
diesel engine gas engine |
|||
| Small fluctuation, small shock, small starting torque, no reverse rotation | 1.0 | 1.5 | 2.0 | ||
| Moderate fluctuation, moderate shock, no reversal (Most common case) |
1.5 | 2.0 | 2.5 | ||
| Large fluctuations, large impacts, reverse rotation under load, starting under load | 2.0 | 2.5 | 3.0 | ||
- Notes: 1. Additional charges based on the operating time of the chain coupling (when the speed is 50 r/min or more)
8 hours to 16 hours per day......0.5
16+ hours/day......1.0
- Note 2) The above Service factor table is a general guideline. Please determine the usage coefficient taking into consideration the conditions of use.
[Reference] Relationship between torque, transmitted power and rotational speed
T = 9550 × P n T = 974 × P n
- T: Torque N・m
- P: Transmission power kW
- n: rotation speed r/min
3. Backlash amount
| Model number | CR4012 | CR4014 | CR4016 | CR5014 | CR5016 | CR5018 | CR6018 | CR6022 | CR8018 | CR8022 | CR10020 | CR12018 | CR12022 |
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
| Backlash amount (deg) |
2.12 | 1.80 | 1.58 | 1.72 | 1.50 | 1.32 | 1.24 | 1.02 | 1.16 | 0.94 | 1.00 | 0.84 | 0.68 |
Note: The above figures are calculated values and are not guaranteed values.
4. Operating temperature range
| No case | Case included | |
|---|---|---|
| Operating temperature (℃) | -20～200 | -10～80 |
Note: Please consult us if you plan to use the product at temperatures exceeding 80°C with the case.
