technical data Clutch Handling
MZ-G Series Handle with care
- 1. Sprockets and gears to be attached to outer race should be securely attached using bolts with strength classification 10.9 in the tapped holes on the end face of outer race, with the spigot aligning with outer race 's outer circumference B dimension (here). A tolerance of H6 or H7 is recommended for the spigot.
- 2. A shaft diameter tolerance of h6 or h7 is recommended.
- 3. Always use a parallel key and never use the top of the key.
- 4. Please use a JIS B1301-1996 (new JIS) parallel key (normal type). Please note that some model numbers do not conform to the relationship between shaft diameter and key specified in JIS.
- 5. When fitting onto the shaft, apply force to the end face inner race.
- 6. When using a vertical shaft, depending on the rotation speed, it may be difficult for grease to reach the upper bearing. Please contact us.
- 7. If a thrust load is applied to the Cam Clutch, provide a separate device to bear the thrust load.
- 8. The ambient temperature range for use is -5°C to 40°C. If the ambient temperature exceeds this range, please contact us.
- 9. Grease-filled type. No lubrication maintenance required.
