technical data Reducer Small Gear Motor Handling
This section describes general handling of Gear Motor, Hypoid Motor, and Croise Motor.
For details, please refer to Instruction Manuals attached to the product.
storage
If you are not going to use the small gearmotor right away, store it taking note of the following points.
1. Storage location
Store indoors in a clean, dry place.
Do not store outdoors or in places subject to humidity, dust, extreme temperature changes, or corrosive gases.
2. Storage position
At the time of shipment, the product is packed and shipped according to the installation direction. Please store the product in the correct installation direction (upside down, etc.).
In the case of special installation, the grease in the bearing may mix with the lubricating oil and dissolve.
3. Storage Period
- (1) The storage period should be no more than six months.
- (2) If the storage period is more than six months, special rust prevention specifications may be required. Please contact us for details.
4. Use after storage
- (1) Non-metallic parts such as oil seals, oil gauges, and oil filler plugs are susceptible to deterioration due to environmental factors such as humidity and ultraviolet rays. Therefore, after long-term storage, inspect the product before starting operation and replace any parts found to be deteriorated with new ones.
- (2) When starting operation, check for any abnormal sounds, vibrations, or heat. If any abnormalities are found, contact the store where you purchased the product immediately.
