technical data Reducer Miter Bevel Gearbox Handling
This section describes general matters regarding handling.
For details, please refer to Instruction Manuals attached to the product.
5. Daily inspection and maintenance
5-1. Maintenance
- - When performing maintenance, wear appropriate clothing and protective equipment (safety glasses, gloves, safety shoes, etc.) for the work.
- - Keep the surrounding area tidy and safe to avoid secondary disasters.
- ・Make sure to turn off the power and the machine is completely stopped before carrying out the procedure. Also, make sure the power is not turned on accidentally.
- ・ Miter Gear Box and ARA Gear Box become hot during operation, so please be careful as there is a risk of burns if you touch them directly.
5-2. Daily inspection
On a daily basis, please perform maintenance using the necessary measuring tools as described below, paying close attention to the operating conditions.
Be sure to perform daily inspections according to the table below. Neglecting daily inspections may cause problems.
| Inspection items | Inspection contents |
|---|---|
| noise | Is the noise level higher than usual? Are there any abnormal sounds? |
| vibration | Are there any abnormal vibrations or sudden changes? |
| surface temperature | Is it abnormally high? Also, is it rising suddenly? |
| Oil level | Is the oil level at the specified position when stopped? |
| Mounting bolt | Are the installation bolts loose? |
| Chain belt | Is there any looseness? |
| Lubricating oil contamination | Is there any dirt caused by Wear debris? |
| Lubricating oil leak | Is there any oil leakage from the joints of the reducer, oil seals, or lids? |
| Pressure Vent | Is the air vent hole clogged? |
If any abnormality is found during daily inspection, take action according to "Troubleshooting."
If the problem persists, please contact the store where you purchased the product.
6. Disassembly and assembly
- ・Never disassemble the product.
- ・To ensure that this machine performs to its full potential, tooth contact and bearing adjustments have been made.
- If disassembly is required, please contact us.
