Specification	Steel Type Steel Type Highly rust-resistant Stainless steel type
Pin rack type	Flat type Angle type

Usage conditions
Running Incline Angle	β	* * * *	[°]
Total mass of running part	M	* *	[kg]
driving speed	V	* * * *	[m/min]
Wheel bearing friction coefficient	μs	* *
Wheel rolling friction coefficient	μr	* *
Acceleration and deceleration time	t	* *	[s]

Operating status * *

Uniform Load Load with some impact Loads with large impacts

Daily driving time * *

3 hours or less 12 hours or less More than 12 hours

Starts and stops per hour * *

9 times or less 10 or more times

Load Calculation
				Acceleration/deceleration inertia force	Fa		[kN]
				Frictional load force	Ff		[kN]
				Gravity load force	Fg		[kN]
				Load tangential load	Fw		[kN]
Service factor
				Service factor	Ks
tangential speed	Ve		[m/min]	Speed Factor	Kv
Correction Weight
				Corrected tangential load	Ft		[kN]
Frame number selection results
Frame No.				Allowable tangential load	Fp		[kN]

Format designation
Number of pin gear teeth	NT1	* *		Required pin rack total length		*	[mm]

Hub type

B C

Selection model number
Pin gear model number			Pitch	P		[mm]
Pin rack model number			Pin rack overall length	La2		[mm]

Pin gear outer diameter	Do		[mm]	Pin gear rotation speed	n1		[r/min]
Pin gear pitch diameter	Da		[mm]	Pin gear load power	Pw		[kW]

The pin gear outer diameter is an approximate value. Please contact us for a definite value.

Reference model number	This is a frame number that is one size larger. Please use it to ensure safety and compare prices.
Frame No.			Allowable tangential load	Fp		[kN]
Number of pin gear teeth	NT1

Pin gear model number			Pitch	P		[mm]
Pin rack model number			Pin rack overall length	La2		[mm]

Pin gear outer diameter	Do		[mm]	Pin gear rotation speed	n1		[r/min]
Pin gear pitch diameter	Da		[mm]	Pin gear load power	Pw		[kW]

The pin gear outer diameter is an approximate value. Please contact us for a definite value.

This sizing sheet calculates the load tangential load using a general calculation formula. Based on that load tangential load and the specified operating conditions, the sheet shows the results of selection using the selection procedures listed in Pin gear drive unit catalog.
Please consider the characteristics of the equipment you are using and determine for yourself whether the load calculation is appropriate.

calculation formula

Return to previous page